internet via cabo off

ozalinux escreveu:



usando note pra posta isso com o mesmo cabo que liga no pc. então cabo ok.

root@theftserver:/home/administrador# sudo ifconfig || sudo ip addr show
eth0 Link encap:Ethernet Endereço de HW c8:9c:dc:c0:39:29
endereço inet6: 2804:14c:5581:1773:ca9c:dcff:fec0:3929/64 Escopo:Global
endereço inet6: fe80::ca9c:dcff:fec0:3929/64 Escopo:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Métrica:1
pacotes RX:371 erros:0 descartados:0 excesso:0 quadro:0
Pacotes TX:35 erros:0 descartados:0 excesso:0 portadora:1
colisões:0 txqueuelen:1000
RX bytes:40640 (40.6 KB) TX bytes:6235 (6.2 KB)
IRQ:46

lo Link encap:Loopback Local
inet end.: 127.0.0.1 Masc:255.0.0.0
endereço inet6: ::1/128 Escopo:Máquina
UP LOOPBACK RUNNING MTU:16436 Métrica:1
pacotes RX:237 erros:0 descartados:0 excesso:0 quadro:0
Pacotes TX:237 erros:0 descartados:0 excesso:0 portadora:0
colisões:0 txqueuelen:0
RX bytes:20424 (20.4 KB) TX bytes:20424 (20.4 KB)




root@theftserver:/home/administrador# sudo lspci -v
00:00.0 Host bridge: Intel Corporation 2nd Generation Core Processor Family DRAM Controller (rev 09)
Subsystem: Elitegroup Computer Systems Device 7b97
Flags: bus master, fast devsel, latency 0
Capabilities: [e0] Vendor Specific Information: Len=0c <?>
Kernel driver in use: agpgart-intel

00:02.0 VGA compatible controller: Intel Corporation 2nd Generation Core Processor Family Integrated Graphics Controller (rev 09) (prog-if 00 [VGA controller])
Subsystem: Elitegroup Computer Systems Device 7b97
Flags: bus master, fast devsel, latency 0, IRQ 44
Memory at fe000000 (64-bit, non-prefetchable) [size=4M]
Memory at d0000000 (64-bit, prefetchable) [size=256M]
I/O ports at f000 [size=64]
Expansion ROM at <unassigned> [disabled]
Capabilities: [90] MSI: Enable+ Count=1/1 Maskable- 64bit-
Capabilities: [d0] Power Management version 2
Capabilities: [a4] PCI Advanced Features
Kernel driver in use: i915
Kernel modules: i915

00:16.0 Communication controller: Intel Corporation 6 Series/C200 Series Chipset Family MEI Controller #1 (rev 04)
Subsystem: Elitegroup Computer Systems Device 7b97
Flags: bus master, fast devsel, latency 0, IRQ 43
Memory at fe508000 (64-bit, non-prefetchable) [size=16]
Capabilities: [50] Power Management version 3
Capabilities: [8c] MSI: Enable+ Count=1/1 Maskable- 64bit+
Kernel driver in use: mei
Kernel modules: mei

00:1a.0 USB controller: Intel Corporation 6 Series/C200 Series Chipset Family USB Enhanced Host Controller #2 (rev 05) (prog-if 20 [EHCI])
Subsystem: Elitegroup Computer Systems Device 7b97
Flags: bus master, medium devsel, latency 0, IRQ 16
Memory at fe507000 (32-bit, non-prefetchable) [size=1K]
Capabilities: [50] Power Management version 2
Capabilities: [58] Debug port: BAR=1 offset=00a0
Capabilities: [98] PCI Advanced Features
Kernel driver in use: ehci_hcd

00:1b.0 Audio device: Intel Corporation 6 Series/C200 Series Chipset Family High Definition Audio Controller (rev 05)
Subsystem: Elitegroup Computer Systems Device 7b97
Flags: bus master, fast devsel, latency 0, IRQ 45
Memory at fe500000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [50] Power Management version 2
Capabilities: [60] MSI: Enable+ Count=1/1 Maskable- 64bit+
Capabilities: [70] Express Root Complex Integrated Endpoint, MSI 00
Capabilities: [100] Virtual Channel
Capabilities: [130] Root Complex Link
Kernel driver in use: snd_hda_intel
Kernel modules: snd-hda-intel

00:1c.0 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 1 (rev b5) (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
Capabilities: [40] Express Root Port (Slot+), MSI 00
Capabilities: [80] MSI: Enable+ Count=1/1 Maskable- 64bit-
Capabilities: [90] Subsystem: Elitegroup Computer Systems Device 7b97
Capabilities: [a0] Power Management version 2
Kernel driver in use: pcieport
Kernel modules: shpchp

00:1c.4 PCI bridge: Intel Corporation 6 Series/C200 Series Chipset Family PCI Express Root Port 5 (rev b5) (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=00, secondary=02, subordinate=02, sec-latency=0
I/O behind bridge: 0000e000-0000efff
Memory behind bridge: fe400000-fe4fffff
Capabilities: [40] Express Root Port (Slot+), MSI 00
Capabilities: [80] MSI: Enable+ Count=1/1 Maskable- 64bit-
Capabilities: [90] Subsystem: Elitegroup Computer Systems Device 7b97
Capabilities: [a0] Power Management version 2
Kernel driver in use: pcieport
Kernel modules: shpchp

00:1d.0 USB controller: Intel Corporation 6 Series/C200 Series Chipset Family USB Enhanced Host Controller #1 (rev 05) (prog-if 20 [EHCI])
Subsystem: Elitegroup Computer Systems Device 7b97
Flags: bus master, medium devsel, latency 0, IRQ 23
Memory at fe506000 (32-bit, non-prefetchable) [size=1K]
Capabilities: [50] Power Management version 2
Capabilities: [58] Debug port: BAR=1 offset=00a0
Capabilities: [98] PCI Advanced Features
Kernel driver in use: ehci_hcd

00:1f.0 ISA bridge: Intel Corporation H61 Express Chipset Family LPC Controller (rev 05)
Subsystem: Elitegroup Computer Systems Device 7b97
Flags: bus master, medium devsel, latency 0
Capabilities: [e0] Vendor Specific Information: Len=0c <?>
Kernel modules: iTCO_wdt

00:1f.2 SATA controller: Intel Corporation 6 Series/C200 Series Chipset Family SATA AHCI Controller (rev 05) (prog-if 01 [AHCI 1.0])
Subsystem: Elitegroup Computer Systems Device 7b97
Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 42
I/O ports at f0b0 [size=8]
I/O ports at f0a0 [size=4]
I/O ports at f090 [size=8]
I/O ports at f080 [size=4]
I/O ports at f060 [size=32]
Memory at fe505000 (32-bit, non-prefetchable) [size=2K]
Capabilities: [80] MSI: Enable+ Count=1/1 Maskable- 64bit-
Capabilities: [70] Power Management version 3
Capabilities: [a8] SATA HBA v1.0
Capabilities: [b0] PCI Advanced Features
Kernel driver in use: ahci

00:1f.3 SMBus: Intel Corporation 6 Series/C200 Series Chipset Family SMBus Controller (rev 05)
Subsystem: Elitegroup Computer Systems Device 7b97
Flags: medium devsel, IRQ 10
Memory at fe504000 (64-bit, non-prefetchable) [size=256]
I/O ports at f040 [size=32]
Kernel modules: i2c-i801

02:00.0 Ethernet controller: Qualcomm Atheros AR8151 v2.0 Gigabit Ethernet (rev c0)
Subsystem: Elitegroup Computer Systems Device 8151
Flags: bus master, fast devsel, latency 0, IRQ 46
Memory at fe400000 (64-bit, non-prefetchable) [size=256K]
I/O ports at e000 [size=128]
Capabilities: [40] Power Management version 3
Capabilities: [48] MSI: Enable+ Count=1/1 Maskable- 64bit+
Capabilities: [58] Express Endpoint, MSI 00
Capabilities: [6c] Vital Product Data
Capabilities: [100] Advanced Error Reporting
Capabilities: [180] Device Serial Number ff-c0-39-29-c8-9c-dc-ff
Kernel driver in use: atl1c
Kernel modules: atl1c

root@theftserver:/home/administrador# ping 8.8.8.8 -c 1 && uol.com.br -c 1
connect: Network is unreachable

p4ulodi4s escreveu:



Ok. Quando você executou os comandos, o cabo estava no seu notebook ou no computador que está com problema?



Linux Professional Institute - LPIC-1
Novell Certified Linux Administrator - CLA
Oracle Certified Associate, Java SE Programmer - OCA
computador, tirei so depois que terminei os comandos pra testar tua dica
http://twitter.com/p4ulodi4s
http://www.prminformatica.com.br/

p4ulodi4s escreveu:



Ok. Quando você executou os comandos, o cabo estava no seu notebook ou no computador que está com problema?



Linux Professional Institute - LPIC-1
Novell Certified Linux Administrator - CLA
Oracle Certified Associate, Java SE Programmer - OCA

http://twitter.com/p4ulodi4s
http://www.prminformatica.com.br/

p4ulodi4s escreveu:

Certo.

No notebook você configurou um IP ou só colocou o cabo e já funcionou?

Se foi só colocar o cabo, tente executar esse comando no computador:

sudo dhclient eth0

 

Com o cabo no computador.


Linux Professional Institute - LPIC-1
Novell Certified Linux Administrator - CLA
Oracle Certified Associate, Java SE Programmer - OCA

http://twitter.com/p4ulodi4s
http://www.prminformatica.com.br/

ozalinux escreveu:


so coloquei o cabo.
root@theftserver:/home/administrador# sudo dhclient eth0
Rather than invoking init scripts through /etc/init.d, use the service(8)
utility, e.g. service smbd reload

Since the script you are attempting to invoke has been converted to an
Upstart job, you may also use the reload(8) utility, e.g. reload smbd

ozalinux escreveu: